If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hope a lot of folks out there read and "get" this; it'll help both sides. I liked big scary dude's attitude toward not pressuring, but more women honestly saying "no" is probably a bit more realistic expectation.
A fascinating analysis of why it's so difficult for women to turn down a guy.
My guess is that the hard part is mounting him in the lathe so he's held rigid, allowing a uniform cut, rather than whipping around. After that, it's simple - 300 RPM, 0.025" depth of cut, 0.010" feed.
Any fool can piss on the floor. It takes a talented SC to shit on the ceiling.
...is mounting him in the lathe so he's held rigid...
After the first pass, he may be dizzy, but definitely not rigid!
I am not an a**hole. I am a hemorrhoid. I irritate a**holes!
Procrastination: Forward planning to insure there is something to do tomorrow.
Derails threads faster than a pocket nuke.
Comment